Applications
Remix Internal and External Render is
suitable for use as a traditional two part rendering system for internal
and external use in moderate exposure conditions.
Quality
The mix is a kiln dried, pre blended,
factory produced 1:1:5 to 6 cement lime sand render
incorporating a waterproofing agent.
Mixing Instructions
To overcome any potential segregation
that has occurred in transit, thoroughly mix the maxi bag contents
before use.
The contents of the bag can be
mechanically mixed in a free fall mixer for 3-4 minutes or hand mixed by
pouring the contents onto a clean, flat surface and slowly adding clean
water in increments and mixing continuously until the desired
workability is achieved.
For optimum results approximately 2.5 to
3.0 litres of clean water should be used per bag. Render should be used
within 60 minutes of water addition.
Refrain from excessive water addition as
this will weaken the mix, delay setting times, adversely affect
durability and may also result in colour variance.
In the case of render applications to
high absorbency masonry units and/or high ambient temperatures, rapid
moisture loss should be prevented by pre wetting the masonry or
substrate.
There is no need to add further additives
or admixtures to the material on site as all required
plasticizers/workability aids are already incorporated into the mix |
